New wheels seem to be available
Discussion
JBliss said:
Scooby P1 said:
Matt - how much to make my headlights into 3R whilst my slave cylinder gets fixed at some point this winter?
I believe it is many pennies!..Hmm the second from bottow are perfect,7043 yummy..
Hmm they all seem to have 5 studs though ...i often wonder if anybody found a 5 stud replacement hub, it sseems a standard Ford/Jaguar bearing, so i suppose there must be a 5 stud hub to fit from ford.
Only £39 for a new hub, it may actually work out cheaper and easier than getting bespoke alloys made.
Hmm they all seem to have 5 studs though ...i often wonder if anybody found a 5 stud replacement hub, it sseems a standard Ford/Jaguar bearing, so i suppose there must be a 5 stud hub to fit from ford.
Only £39 for a new hub, it may actually work out cheaper and easier than getting bespoke alloys made.
Ultima runs ford granada hubs which are the ford 5 stud... almost no wheels available in the correct size/offset so wheels are around 2k plus tyres.
BMW might be closer offsets and some bmws run wider rears to front so possible...
either way you need new brake bells on front at around £250 and a lot more for the rears!
BMW might be closer offsets and some bmws run wider rears to front so possible...
either way you need new brake bells on front at around £250 and a lot more for the rears!
key750 said:
Bells are easy to reholed and machined on the center bore.
Some wheel spacers are multi hole (simoni racing) , why not do it same with brake bells! :-)
pretty sure the wheel center for BMW is smaller than ford... you cant re-hole for that Im afraid... you could of cause fit a spacer but Im never keen on that!Some wheel spacers are multi hole (simoni racing) , why not do it same with brake bells! :-)
andygtt said:
pretty sure the wheel center for BMW is smaller than ford... you cant re-hole for that Im afraid... you could of cause fit a spacer but Im never keen on that!
3 Series E46 = PCD 5x120, centre bore 72.5mm and M12x1.5 bolt thread. ET 30-47Noble = 8x18 10x18 /// 4x108. 63.4 c.bore et23/30
Central bore and holes problem are solved... now spline problem!
I hope this helps:
http://www.escortrscosworth.com/forum/showthread.p...
For me and my bad english it's hard to understand perfectly....
http://www.escortrscosworth.com/forum/showthread.p...
For me and my bad english it's hard to understand perfectly....
Gassing Station | Noble | Top of Page | What's New | My Stuff