Carbon Fibre Fender louvres

[TIGERSIX]

Adrian W said:

Which bit?

Looks like you have had an e-vent-full play meshing about with you car Winch

[Adrian W]

Now that was sad, it's been like that for ages :-)

[TIGERSIX]

Adrian W said:

Now that was sad, it's been like that for ages :-)

Well it was good for someone from Norfolk be honest and I havent had a glass of wine yet

[TuxMan]

Got mine fitted today thanks to Matt and Dave at Jetstream , lovely quality and fit very very well , the new rear ones look good too , hopefully get them fitted after Le man and spa .also they fixed my dodgy idle and creaking steering rack as well , great service as normal .





Tux

[shaunsmith]

They look superb, I'm next

[mgbond]

Tux,

Have you not considered the adjustable front splitter that Adrian has for track?

[TuxMan]

Hi Bondy , pretty pleased with car setup now so don't think I will do much more aero work , not sure the supports are adjustable , thought they were just to support the front edge of the splitter .

Tux

[patsrocket]

Tux,
How did they secure them in?
Were there screws or just bonded in with glue?

[tonyvan]

hi Pat, some vents come with bolts glued to them. some are avaliable without the bolts and considerably cheaper by over £100 pair!!!!!. if you go for them, you can either bond them in place or buy 8 flat head bolts and bond them in with q bond, thats what i did,and saved £100.

[StreetDragster]

tonyvan said:

ive doing some test on them to determine air flow through them and feed back so far looks good.

Genuinely interested in this, how do you test the air flow through them? Wind tunnel with smoke?

[Zoobeef]

These are the ones the VX220 guys stick in.


Not sure if the shape will fit the lines of the Noble though. An option I might be trying on my track car though is the ones from the bonnet of the focus rs.

[patsrocket]

I have the same one TUX has from Jetstream.

[tonyvan]

StreetDragster said:

Genuinely interested in this, how do you test the air flow through them? Wind tunnel with smoke?

Anometers

[Olliew321]

Hi,

I bought these ones of the internet and did them myself with self tappers.

[SwankBaton]

Where did you get those from? Got a link?

[Zoobeef]

swankBaton said:

Where did you get those from? Got a link?

They look like focus rs bonnet ones.
This is the first link when I searched so may be available cheaper.

http://streamlinecarbon.com/v2/products-page/body-...

[Plumber1]

Zoobeef said:

These are the ones the VX220 guys stick in.


Not sure if the shape will fit the lines of the Noble though. An option I might be trying on my track car though is the ones from the bonnet of the focus rs.

I've got a set of those in the garage, lot of work involved in fitting them to a vx