Considering an M12
Discussion
Alpinestars said:
Would you mind posting details of how to do this please?
Check out this thread it has all the info. Very simple to so as you use all the existing pipework, no cutting required so all reverseable.http://www.pistonheads.com/gassing/topic.asp?h=9&a...
Steve
stevegto3 said:
Check out this thread it has all the info. Very simple to so as you use all the existing pipework, no cutting required so all reverseable.
http://www.pistonheads.com/gassing/topic.asp?h=9&a...
Steve
Thank you. http://www.pistonheads.com/gassing/topic.asp?h=9&a...
Steve
stevegto3 said:
Alpinestars said:
Would you mind posting details of how to do this please?
Check out this thread it has all the info. Very simple to so as you use all the existing pipework, no cutting required so all reverseable.http://www.pistonheads.com/gassing/topic.asp?h=9&a...
Steve
Yes thats true, simple remedy just rivet two circular alloy patches, using the old filter screw holes - thats what I did.
Steve
Steve
Blu3R said:
Just be aware that you'll end up leaving two gaping holes in the IC box that you'll need to block/cover if you want to maintain flow through the IC.
Alpinestars said:
Blu3R said:
Just be aware that you'll end up leaving two gaping holes in the IC box that you'll need to block/cover if you want to maintain flow through the IC.
I was hoping you were going to help me do it Rob!Gassing Station | Noble | Top of Page | What's New | My Stuff