Discussion
Hi all,
A donkey was out in the Racer and had some fun recently.
Sadly i(t) managed to break the lefthandside drive shaft.
A fast check showed it is not a Griff/Chim shaft as it is much shorter
by about 10 cm.
Any hints what drive shaft would fit or for best place to purchase one
are greatly appreciated.
Would you recommend any kind of donkey approved ones?
Thanks very much and best regards,
Griffithy
Hi, thanks very much for your reply.
I could get the drive shaft out now.
It comes quite close to your drawing, but I think mine is a bit shorter
in overall length.
Overall length "L" would be ca. 430 mm in situ and ca. 450 mm out.
Hole Dia "H" 10 mm
No of Theeth "Z" 28
PCD "P" ca. 93 mm
Joint Dia "D" ca. 108 mm
Joint With "W" ca. 41 mm
Overall Length "L" ca. 430 mm (in situ)
Overall Length "L" ca. 450 mm (out)
Best regards,
Griffithy
Gassing Station | General Motorsport | Top of Page | What's New | My Stuff