Login | Register
SearchMy Stuff
My ProfileMy PreferencesMy Mates RSS Feed
Tim Davis
my Trailer for sale, Ifor Williams twin axle, braked, lockable tool box, high tyre rack, brand new A frame and lights. excellent tyres and general condition, in the classifieds for £1750 but £1600 to a racer on here.

Nick Simpson
Tuscan 4.7 AJP unfinished but not far off... http://www.pistonheads.com/classifieds/used-cars/t...


Dave Chant (NTEL)

Got my fully rebuilt T5 race box for sale due to installation of a TKO600. Lots of tricky billet and bronze bits in there as well as the close ratio straight cut 5th. Other gears are wide ratio ideal for the Rover V8 but will make a great spare for AJP engined cars.

Giz a ring to discuss prices 07973 920696

Dave

(77racing)

Complete set of Titan roller rockers, shafts , bolts and posts C/W a pair of TVR branded deep rocker covers to fit as well. Fits Rover V8 3.5 to 5.5lts

GKN 3.3 Diff all in good working order not long being overhauled and checked out, spare from my Rover Tuscan

F/N/S lower suspension arm £185

World class top notch condition T5 gearbox for sale . It is a race box and has close ratio straight cut 5th. Now Available only one left

1x Tuscan Challenge race car Group A+ Chevrolet LS3 all the fast bits fitted no vodka & Tonic(Now Just come runner up in Castle Combe GT Class A Championship and now holds the Combe GT out right lap record now at 1:09.23.( beat that if you can )I will be lowering that again next year

Ajp to T5 bell housing £325
1x Tuscan 4mm scratch guard Polycarbonate front windscreen new never fitted £235.00
1X Tuscan Challenge Rover 4.5 short engine only a few hours used, new crank,pistons,rods bearings etc all the right parts ready to be used.
Standard Chevrolet LS3 Rods and Pistons/Rings
2x Quick refueling dump churns with fittings need resealing i think £450 Pr will split, also have one churn stand on wheels
5 x 16" OZ Racing 5 spoke split rims ( The Originals )
1x used but well servicable body shell/tub very cheap and all complete would suit a home build project or for panel parts at the very least £400
Front aluminium under belly splitter fits Tuscan (used same as seen fitted to white car 77)
1x New unused roll cage to fit in Tuscan c/w side impact bars
2x Ali fuel tanks different sizes
LT 77 gearbox (from a 1994 griff sold as seen as i have no history)
3" straight through stainless muffler exhaust will fit tuscan RV8 or AJP etc
1x Oz 18" split rim
Tuscan fibreglass dash consol choice of two
1X Front Collector 3" exhaust pipe with top muffler down to main muffler suit Rover £250
1pr Exhaust primery's suit AJP engine
Front air dam and splitter new unused for tuscan £225
Passenger side tonau fibreglass panel choice of two £140 each
Nascar re-fuelling dump churn interesting memorabilia on your garage wall unused £75


Leerdam23

Pair Compomotive 18 x 9 inch MO6 rims, only done about 300 laps since the car was used only for sprinting - £300



tuscan Challenge car No 42 for sale ref. TVR MADS
Link:- http://www.tvr-mads.co.uk/TuscanRacer.html

1980-? TVR 280i/Tasmin/Wedge Racecar
Tasmin Challenge spec:
Ford 2.8 cologne V6 engine fitted with triple downdraught carbs
4 speed type 5 gearbox
3 sets of 15” Compomotive Alloys (2 with slicks, 1 with wets)
“quikrack” type steering rack
Polycarbonate windows throughout
Adjustable brake bias
Extremely competitive when last raced in 2012 in class C of the Challenge
Call 07824 565147 for more info
James Knight


jbm
chevy LS2 engine
built by john eales engines
race rods and pistons flowed heads
needs a john ealse front cover and sump pan as these are now on the new engine
500bhp
fast and reliable






teamholdenracing
Tuscan parts:
1 set of brake pads (Mintex) for 4 pot front AP brakes (Tuscan)- new
Pair of downpipes for AJP engined Tuscan
1 pair rear body work stays
1 Bosch fuel filter
1 pair Tuscan challenge set up string bars. These locate on the socket head bolts for the suspension in the four corners of the car, cable tie to the chassis. They protrude out the sides of the car and enable you to quickly set up a string box to check toe in/out. Very useful bit of kit!
1 x AJP wiring harness for Tuscan (new and unused, pin-out tested)
Prop shaft for AJP Tuscan. Good condition
6 x sets Performance Friction brake pads for 2 pot Tuscan rear AP brakes (also suitable for standard front brakes on Lotus Elise) - new
LS6 parts:
2 x air boxes for Mosler for Kinsler throttle bodies with large panel filters







6r4.com
Hi,
I have a set of front AP racing front calipers available on ebay...
They are for a TVR Tuscan Challenge Car.

http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&am...



kg55
The engine you all want is up for sale AJP4.5 with 4.2 induction reidys race cams etc its the one out of the tuscan. T5 gearbox (selector at the end of the remote) will swap for T5 box with the selector further forward.Mail me for any info price etc

mikeah( Mike Haig)
TVR Tuscan Challenge Project
This project includes Chassis, Cage, new front and rear wishbones, new rear uprights, front uprights, BTR diff, drive shafts, ARB. Plus much more, including exhaust, AJP loom etc.
Bargain at £1950 .
Also available seperately, Rover TVR V8 engine. This is a fully rebuilt proper 4 bolt engine with Dry sump pump, pan and tank, Quad Dllerotos etc. This is a superb engine and a genuine bargain at £5250. 07826657924

Wedge 2+2 Body shell

tasmin open top race car, built by rt and laterly moore racing. fitted with cosworth 2ltr turbo and very successfull in its day. This car has had a front end accident and requires a new nose ( included) and minor repair to front body mount but otherwise straight and runs. Fairly straight forward fix and cheap reliable way in to racing. Its at RT-Racing but being sold by the owner.


Graham
Tasmin race car parts

S1 boot lid ( outer only)
S1 nose upto and inc blukhead
s1 1 piece front end
s1 350 bonnet ( outer only)
s1 280 front spoiler
s2 280 front spoiler
S2 1 piece front end

Tuscan Headlight pods

Chimaera Fast back Hardtop
Chimaera 1 Piece front end





ceejay
3.1 V6 Cosworth Twin Turbo engine requiring a rebuild. Ideal for Class B. Offers
Tasmin race car parts


PeteSBC

350SE ex Greenstar(Micky Holden) Now running 4.6 RV8 £8500
Tasmin race car rolling chassis fully caged with Comp MO's £600
Tasmin 2.9 Cosworth class C. SEAC front end needs wiring and exhaust finishing. Rebuilt 4 speed new Quaife Diff £3000

Ben T
TVR Tuscan Challenge Parts
3 x Tuscan Challenge MBE ECU'S POA
1 X Tuscan AJP Wiring Harness (Used) POA
1 X Tuscan Header Tank (Used) POA
1 X Tuscan Water pipers (Used) POA
1 X Tuscan Bellhousing (With Clutch Release Bearing and Bleed Pipe) POA
1 X Tuscan AP Racing Clutch
1 X Tuscan Upright POA
1 X Tuscan Gear Stick POA
2 X AP Front Discs With Bells POA
1 X Bosch Fuel Pump POA
1 X Tilton Pedal Box
Numberous New and Used Brake Pads (SBS,MINTEX) POA
Contact Ben Taylor bentaylor1989@aol.com


ctsdave Dave Stewart

Got a few bits of V8 stuff for sale:

RV8 crank x-drilled from 4ltr racer engine. Not checked but looks OK.
Cone diff as per Tuscan racers.

Set of Dellorto dhla 48 carbs complete with everything except manifold plus spare jets, trumpets and filter.

Contact me for details - comtruck@hotmail.co.uk or 07836 795918


Tuscan_No27 (Richard)
Complete race Tuscan exhaust system for AJP8 engine. In great nick.
Now on eBay http://www.ebay.co.uk/itm/TVR-Tuscan-Challenge-AJP...
Also AJP8 wiring harness (not sure if complete). Going to the tip unless I get a beer tokens offer. richard@paynters.co.uk

SARBEC for sale
Cosworth v6 recent rebuild rings shells chains guides heads all been done manifolds fitted that will suit a tasmin all ready to bolt in