Progress report.
Discussion
As you may have read from other posts, my race engine is currently toast.
So converted the Test 3.9 engine I had, put in a 4.0 non dissy camshaft (the one in there was shot so not a bad thing) put on the new style front cover, and our custom induction.
All fired up fine, done a bit of tweaking, and did a full test at Brands, Oil was getting a bit hot so fitted an oil cooler
So now we are all set for our 1st race at Rockingham
So converted the Test 3.9 engine I had, put in a 4.0 non dissy camshaft (the one in there was shot so not a bad thing) put on the new style front cover, and our custom induction.
All fired up fine, done a bit of tweaking, and did a full test at Brands, Oil was getting a bit hot so fitted an oil cooler
So now we are all set for our 1st race at Rockingham
I've Think I've finally found my fuel leak, while doing a refresh on the rear end, new bearings and callipers and pads.
I was sure when I removed the tank I could not find a fuel return, but now I think I've spotted one, need to check though that it's not blocked. in hindsight I should have asked Kev
I was sure when I removed the tank I could not find a fuel return, but now I think I've spotted one, need to check though that it's not blocked. in hindsight I should have asked Kev
Update on the broken turret.
See pictures here
http://www.facebook.com/media/set/?set=a.101503614...
I've nearly finished redesigning a new one from a 3mm sheet of steel.
top is cut to fit the coil-over mod. see pic 5 in link below
bottom is cut and ready for bending see pic 6 in link below.
Then I just need to weld it up, drill hold for wish-bones, and then weld to chassis.
http://www.facebook.com/media/set/?set=a.480952337...
See pictures here
http://www.facebook.com/media/set/?set=a.101503614...
I've nearly finished redesigning a new one from a 3mm sheet of steel.
top is cut to fit the coil-over mod. see pic 5 in link below
bottom is cut and ready for bending see pic 6 in link below.
Then I just need to weld it up, drill hold for wish-bones, and then weld to chassis.
http://www.facebook.com/media/set/?set=a.480952337...
Bump for Alex.
Also have suspension pic's here
http://www.facebook.com/media/set/?set=a.451939192...
Also have suspension pic's here
http://www.facebook.com/media/set/?set=a.451939192...
Edited by TVRleigh_BBWR on Monday 11th June 14:32
Gassing Station | General Motorsport | Top of Page | What's New | My Stuff