My Peugeot 205gti (Dimma) Restoration
Discussion
Great project.
There was another thread I followed a couple of years ago about a guy who restored one and put a Cosworth engine in with 4x4 running gear!!!
http://www.detailingworld.com/forum/showthread.php...
There was another thread I followed a couple of years ago about a guy who restored one and put a Cosworth engine in with 4x4 running gear!!!
http://www.detailingworld.com/forum/showthread.php...
Lol, since my last post, 1 page back I have bought a similar car, in red, kitted up, running 4x4 Cossie.....it is bonkers and I have started to restore it...still got the gti gti6 too so the wife is a little "confused"
Will get some pics up when I finish sorting out the interesting wiring....it is mentally fast!
Will get some pics up when I finish sorting out the interesting wiring....it is mentally fast!
I have spent a few hours today stripping the paint off the drivers side floor and found a few holes that will need cutting out and plating but nothing that cannot be repaired I have started to make a template for one of the bigger bits that need doing. Strange thing is that most of this rot has come fro the inside and rotted out im sure floorpan must have been soaked in water at some point.
I have allready welded some smaller holes up and dressed them up just got to get some sheet steel to carry out repairs and the spit should be ready in a few weeks so can really make headway into the floor and sills.
It looks great so far can not wait to see it finished! There is one of these Dimma kitted 205s were I am the last time I saw it was a few years ago under some old car parts I think its still there abandoned! Its near an Nsu Ro80 thats also been left near by. The things people abandon!
Well I have started to cut rot from drivers side floor and have started to weld new plates in.
Rot cut out.
Then welded parts in managed to do one plate and dress up the other I have managed to tack but unable to fully weld yet as I dropped something on my auto darking welding lens so have a new welding mask coming.
Rot cut out.
Then welded parts in managed to do one plate and dress up the other I have managed to tack but unable to fully weld yet as I dropped something on my auto darking welding lens so have a new welding mask coming.
Heres another small update managed to get plate made and welded in front part of foot well not sure what the curved bit was for but I included it into the new panel I made cleaned welds off all thats left is to wait til car up on spit and weld from underside anywhere that needs doing.
Gassing Station | Readers' Cars | Top of Page | What's New | My Stuff