Scratch built car
Discussion
I finished of fitting the hatch by tacking the tapped pins (weld later) to the roll bar, I then made up the rear support cross member, aluminium spacers and then cut off the back end of the hatch by 400mm and welded on the closing panel, so now I can style the rear end of the car as I like. All I need to do now is finish off the sides and then fit the ‘D’ section seal to the hatch flange. Andy
I made up the rear closing panel which fits behind the rear of the door frame using the same jig I used for the door frame. The gap between the closing panel and the door frame will reduce by 3mm from 8mm to 5mm when the door skin and rear wheel arch panel are folded around the frames. The panel will be welded in when I have all the panels/air inlet in position. Andy
Gassing Station | Readers' Cars | Top of Page | What's New | My Stuff