Help please, there are three boxes that are in some way connected to the dim/dip setup.
One of mine does not have a connecter on it so when unplugged the order the of the spade terminals that were plugged in was lost .
Could somebody photograph them and stick them on here, the wiring diagram is un helpful .
The two on the right hand side of the car when standing at the back looking into the boot seem to be the most important.

Will any of these help?

What's the box in the last picture do? My Dim/Dip has burnt out, but wondering if that other box has anything to-do without my high beams not working.

That one's over towards the left, mine has tape on it which means it's been fetled at some point. curiousity is getting the better of me.

Thw last box puts the dip beam lights on at the same time as the side lights but at half voltage,sort of parking lights with the ignition off ,the brightness of the dip can be adjusted by a pot on the circuit board.