Poorly Cerb - Won't start/running very rough
Discussion
waveydavey1000 said:
Racetech deliver next day and txt the time of delivery, or you can specify a safe place or neighbour
Yeah, had excellent service off them for the new leads.. However they want £120 for a coil pack.. I paid £43 (for Bosch ones!) Just didn't expect it to take so long to get here.Well.. It is running even-ish compression across all 8 cylinders.
Coilpacks didn't turn up, so changed leads and plugs. Rear drivers cylinder lead was shorting on the exhaust manifold and heat damaged and breaking up.
Still won't run properly, but "running" much better than it was.. Fuel filter and coilpacks to go. It is running colder to touch on No.3 cylinder on the driver's bank. Going to get diagnostics on it as well next weekend.
Coilpacks didn't turn up, so changed leads and plugs. Rear drivers cylinder lead was shorting on the exhaust manifold and heat damaged and breaking up.
Still won't run properly, but "running" much better than it was.. Fuel filter and coilpacks to go. It is running colder to touch on No.3 cylinder on the driver's bank. Going to get diagnostics on it as well next weekend.
ukkid35 said:
I strongly recommend routing the HT leads between the water rails and the heads (rather than over the water rails). If you are using bog standard leads you can feed them between the rails/heads without removing the water rails.
Out of interest why between? Chaffing/heat? They are currently routed back as they were found.Gassing Station | Cerbera | Top of Page | What's New | My Stuff