Front tracking / wheel adjustment

[Scarface1]

Hi Guys.

Just after a bit of advice.

After putting the backend back on the Cerb, one of the rear wheels was not sitting dead centralised in the arch.

I have now adjusted this and the car will be going for 4 wheel tracking, toe etc set up so I was not too worried.

However the fronts are a bit off also.

Is there a way to move the wheel back and forward in the arch to centre it or is that fact its slightly off just a TVR thing where all cars are slightly different shell wise (i know some people have had to grind off some glassfibre to get wheels on whilst others have not.)

I currently have some 18 x 8 Rota GTR ET30 I am trying to fit.

they currently have 235/40/18s on but these are catching on lock.

Whilst I will be dropping the tyre size any adjustment would help.

Thanks

Steve

[tofts]

Short answer, No.

Depending on how arduous you wish to make the quest then it is possible. The wishbones are held in place with bushes and whilst it is theoretically possible to trim one side of the arm and shim the other side, i'm not sure its the method you are after!

[Scarface1]

As I suspected.

Thanks for the reply.

All the best.

Steve