Discussion
I have a megasquirt ms2 Ecu that I bought a couple of years back that I'm now trying to wire up but I think it may be screwed . I suspect that the previous owner wired it wrong . If one of the coil or injector outputs was connected to 12v could that damage the board ? It powers up and I can see all the sensors etc but it doesn't see any thing from the crank sensor on either of the vr input lines . Haven't got a scope but there's an ac voltage coming from the crank which uses a factory sensor and trigger wheel ?
A little knowledge is a dangerous thing for me and electronics so il let the other chap sort it out . With all the other sensors working i might be lucky and get it sorted but I'm still not sure how well the ford coil packs can handle boost if I go over wg spring pressure which is only 7 psi .
mighty kitten said:
A little knowledge is a dangerous thing for me and electronics so il let the other chap sort it out . With all the other sensors working i might be lucky and get it sorted but I'm still not sure how well the ford coil packs can handle boost if I go over wg spring pressure which is only 7 psi .
If it's any half modern coil pack, I'd be amazed if it couldnt handle 15-20psi without problem.Gassing Station | Engines & Drivetrain | Top of Page | What's New | My Stuff