Induction kit help
Discussion
Hi all,
I bought a k&n induction kit for my polo 9n3 gti, it's the one made specifically for my car, however I'm having trouble fitting it! Part of the installation is to put the filter adapter onto the maf, however the maf is about a mm to big for the adapter, should I get some sand paper and remove a small amount of rubber to make it fit? Or is there another way as its only a mm away from fitting
Cheers RamJam
I bought a k&n induction kit for my polo 9n3 gti, it's the one made specifically for my car, however I'm having trouble fitting it! Part of the installation is to put the filter adapter onto the maf, however the maf is about a mm to big for the adapter, should I get some sand paper and remove a small amount of rubber to make it fit? Or is there another way as its only a mm away from fitting
Cheers RamJam
As above, a bit of hot water makes it more flexible, but do NOT use oil, you don't know what the chemical make-up of the "rubber" is and anything other than soapy water/water based lubricant should be avoided or it may well significantly affect the "rubber" life etc however unlikely as it is made for an engine bay.
Gassing Station | Engines & Drivetrain | Top of Page | What's New | My Stuff