Bending aluminium
Discussion
Thanks for responding It needs to go as pic:
The flat vertical part goes along the door edge. It curves round the corners of a door, two of which are 90 degrees, two curved as seen.
If I can't diy I'm quite happy to pay someone to do it but question is who?
The flat vertical part goes along the door edge. It curves round the corners of a door, two of which are 90 degrees, two curved as seen.
If I can't diy I'm quite happy to pay someone to do it but question is who?
Edited by GtheD on Friday 2nd December 13:08
Edited by GtheD on Friday 2nd December 13:18
Gassing Station | Bodywork & Detailing | Top of Page | What's New | My Stuff