Yet another question from me,bonnet vents
Discussion
moif said:
How big a difference Moif?Been thinking a little more on how to alleviate under bonnet temps on mine.
On an old Land Rover 90 I had I swapped the 2.5 Petrol out for a 2.5 200Tdi engine from a Discovery, in that fitment the turbo and down pipe come very close to the passenger footwell and I wrapped the manifold, turbo and down pipe with that fiberglass heat bandage. It was very effective, after 10 minutes idling you could hold the manifold and on decent runs there was no heat transfer.
Obviously I wouldn't consider that stuff on mine, I think it was fine for the application on the Landie but I wouldn't want to use it on a performance engine like ours............
Stef
Stef,the difference is massive,cant give you exact figures yet but lifting the bonnet after a run you dont get the blast of heat like you would normally
I've also noticed that i dont get any pops and bangs on the overun now,now if i'm right,because the ceramic keeps the heat inside it escapes out of the exhaust quicker hence no unburnt fuel to pop and bang
It doesnt keep it cold enough to hold the exhaust(i tried....ouch)
According to Zircotec it reduces under bonnet temps by 33%.........the heat difference is very noticable
I've also noticed that i dont get any pops and bangs on the overun now,now if i'm right,because the ceramic keeps the heat inside it escapes out of the exhaust quicker hence no unburnt fuel to pop and bang
It doesnt keep it cold enough to hold the exhaust(i tried....ouch)
According to Zircotec it reduces under bonnet temps by 33%.........the heat difference is very noticable
Gary H 2008 said:
That looks brilliant! You must we properly chuffed with that!
All the way through or or just top skin?
(I went for a slightly more holistic approach - another angle )
ahh I was rooting around trying to find a pic of these !! All the way through or or just top skin?
(I went for a slightly more holistic approach - another angle )
Edited by Gary H 2008 on Saturday 27th September 22:21
I really really like this.. where did you get it done?
Gary H 2008 said:
That looks brilliant! You must we properly chuffed with that!
All the way through or or just top skin?
(I went for a slightly more holistic approach - another angle )
Through both skins.All the way through or or just top skin?
(I went for a slightly more holistic approach - another angle )
Edited by Gary H 2008 on Saturday 27th September 22:21
I don't think there's anyone who does not recognise your car from the vents alone !
Seen them close up, very bold to say the least.
For those that have fitted vents, do you have any problems with rain water dripping
into the engine bay ? (I made some ali drip trays, but don't want to fit them if the
water is not generally an issue)
Gassing Station | HSV & Monaro | Top of Page | What's New | My Stuff