Help needed to source number plates.

[MyM8V8]

mik_ok said:

Very good. A tile saw cuts it quite nicely.

Yeah. Got one of those. Cheers.

Actually, myshowplates were very, very good with feedback and comms. Thoroughly recommend them to get the more difficult custom stuff done.

[MyM8V8]

Rear plate arrived from Alton Plates this morning.

Brilliant service and they translated my requirements perfectly. Thank you, and you are highly recommended.





Thanks to everyone for their suggestions guidance.

Edited by MyM8V8 on Tuesday 23 September 12:07

[preciousmetal]

MyM8V8 said:

Rear plate arrived from Alton Plates this morning.

Brilliant service and they translated my requirements perfectly. Thank you, and you are highly recommended.





Thanks to everyone for their suggestions guidance.

Edited by MyM8V8 on Tuesday 23 September 12:07

Glad all sorted Gareth, Ashley @ Alton is good on plate sizes and shapes and good quality, used him on other Utes and US cars

[MyM8V8]

mik_ok said:

MyShowPlates could only do a 16"x4.5", but biased the text to one side so the text was correctly centered after I trimmed an inch off the width.

It meets all the "import" plate font/spacing requirements.

Front plate arrived from them today, as above, but they had got the 355mm width spot on, just had to trim the depth an inch. Perfect and to myshowplates.

Thanks to all for your input on this one. The "Stroker" is now road ready for some serious data logging.

Edited by MyM8V8 on Friday 26th September 00:02