cold air

[SteveSPG]

buzz kindly sent me a template for his heater cover, absent on my car, so I've started to make one from black gelcoat backed with fibreglass. planned to use a sheet of ali but the sheet i had to hand wasn't large enough...ill use some edge trim on the top side with a deformable seal to snug up against the underside of the nose....

still got to cut this to size once I've offered Buzz's template up to my car, which is off at trimmers for a little work.

[Whitenoise1]

If the template works well would you be able to scan it and make it available to everyone else. If not you could post it to me and I can do it if people will find it useful?

Cheers,

Andy

[SteveSPG]

sure

ill have my car back after the BH, but i can send you a copy of the template, or wait till I've finished mine

pm me your address either way

[Whitenoise1]

Did you ever get this finished? With the warmer weather I'm looking at sorting this again.

If anyone has a template spare. I can make it available online for other people to use?

Cheers,

Andy

[Willfin]

SteveSPG said:

buzz kindly sent me a template for his heater cover, absent on my car, so I've started to make one from black gelcoat backed with fibreglass. planned to use a sheet of ali but the sheet i had to hand wasn't large enough...ill use some edge trim on the top side with a deformable seal to snug up against the underside of the nose....

still got to cut this to size once I've offered Buzz's template up to my car, which is off at trimmers for a little work.

Steve, do you have a copy of the template you could share?