DTC keeps kicking in on 320d E90
Discussion
Whilst driving my car on a motorway/dc the DTC kicks in with the car gradually losing power until I turn off DTC. Sometimes it leaves the ABS, Handbrake, Tyre Pressure warning lights on after DTC is switched off. These normally reset once the car has been switched off. Anyone else had this problem? Seems to be occuring more often now.
I agree with Sinbad and don't forget to press the re-set button after setting the pressures.
In addition, make sure all the tyres are exactly the same size. Some people seem to think that the profile is not too important when the width and diameter correct. I don't know how familiar you are with tyre sizes so I will add that the profile is the middle figure in the size, for instance if the size is 225/45/17 the profile is 45%.
(If you've got staggered sizes the pairs should be matched)
In addition, make sure all the tyres are exactly the same size. Some people seem to think that the profile is not too important when the width and diameter correct. I don't know how familiar you are with tyre sizes so I will add that the profile is the middle figure in the size, for instance if the size is 225/45/17 the profile is 45%.
(If you've got staggered sizes the pairs should be matched)
soapystick said:
I'd put money on it being down to the drive shafts. The toothed gear the the ABS sensors read can distort and actually start touching the sensors, confusing the whole system.
Check the toothed gear for scuff marks.
This, my brothers had the same fault, new drive shafts I'm afraid. Check the toothed gear for scuff marks.
Hello guys. I'm new to the forum and I'm not a mechanic
I've got a similar problem to this but...
Last week I went for a long journey and first after 30 min drive light pop up with the puncture, not long after I've had all the others lights on (abs, puncture and handbrake). Pulled over and check everything and everything was fine. So reset the puncture fault and carry over my journey. After 30 minutes I been keeps getting wheel spinning symbol driving straight on the motorway. I could only get round it by switching DTC off.
I can drive absolutely normal for half an hour and then wheel spinning symbol. I tried it for few days and always the same. All fine only for half an hour. On Saturday I will plug it to ista to read fault. Does anyone got any clue what that could be?? I will be preached for your help.
I've got a similar problem to this but...
Last week I went for a long journey and first after 30 min drive light pop up with the puncture, not long after I've had all the others lights on (abs, puncture and handbrake). Pulled over and check everything and everything was fine. So reset the puncture fault and carry over my journey. After 30 minutes I been keeps getting wheel spinning symbol driving straight on the motorway. I could only get round it by switching DTC off.
I can drive absolutely normal for half an hour and then wheel spinning symbol. I tried it for few days and always the same. All fine only for half an hour. On Saturday I will plug it to ista to read fault. Does anyone got any clue what that could be?? I will be preached for your help.
Gassing Station | BMW General | Top of Page | What's New | My Stuff