A picture a day....biker banter (Vol 3)
Discussion
Andy XRV said:
Fleegle said:
Andy XRV said:
Fleegle said:
3DP said:
Very nice Tony - you got her back on the road, or just wheeled out for a dust off?
Wheeled out for its final once over mate. She's going 3DP said:
Good luck with the sale. Right colours and values probably peaking - lovely looking bike. I look forward to hearing the plans. Endurance racer perchance...? Any plans with the Lav post clear out?
Mitzy has had a sensible offer. I'm sure we could achieve more if we were prepared to hold fast, but selling now puts her in a stronger position for her part of the plans. In summary, we are getting rid of 5 and replacing with 2The Laverda isn't going anywhere at the foreseeable future. It gets turned over every now and again, but time isn't on my side. Maybe thinning out will afford me the time to spend on it, it'll certainly free up some much needed room
spareparts said:
I adore them but I am just not brave enough to put my coin into one.dannyintenerife said:
Oops- had a moment and did this.
Would a clutch cover sort it or do I need a new case?
Just asking opinions as a cover is loads less than a new casing?
Thanks in advance for any help.
Hard to say, your brake lever looks bent as well.Would a clutch cover sort it or do I need a new case?
Just asking opinions as a cover is loads less than a new casing?
Thanks in advance for any help.
you probably could just get away with new casings and gaskets. But they aren't cheap.
http://www.worldoftriumph.com/
shows you what you need.
See your fairing has a bit damage depends how clean you want it. Might be fine as it is just check for seepage
Edited by moanthebairns on Tuesday 18th November 09:25
dannyintenerife said:
Oops- had a moment and did this.
Would a clutch cover sort it or do I need a new case?
Just asking opinions as a cover is loads less than a new casing?
Thanks in advance for any help.
Is that a crack I can see next to the clutch operating mechanism? If it is then a decorative cover isn't going to fix it. You may be able to get it welded. Would a clutch cover sort it or do I need a new case?
Just asking opinions as a cover is loads less than a new casing?
Thanks in advance for any help.
twizellb said:
Biker's Nemesis said:
Front row looks like, Lawson, Koscinki,Doohan, Rainey.I'm guessing 1991 - should have Gardner & Haslam on the grid too.
Mr2Mike said:
dannyintenerife said:
Is that a crack I can see next to the clutch operating mechanism? If it is then a decorative cover isn't going to fix it. You may be able to get it welded. Gassing Station | Biker Banter | Top of Page | What's New | My Stuff