Electric mirrors
Discussion
rabowman said:
Tried for the fourth time to remove the door card yesterday.
No way can I reach the last stud.
Job for a local TVR specialist I think.
Hate giving up!!
Then dont! Stretch like mad or get a mate/missus with boney arms and get them to feel the wrath of fibre glass burns!No way can I reach the last stud.
Job for a local TVR specialist I think.
Hate giving up!!
I dont bother with the last bolt on reassembly, it doesn't rattle.
Mind you, i dont like giving up either but the evil mirrors defeated me :-/
Its a struggle, but as you have to do it pretty often its worth getting the hang of it.
1) Remove Speaker Grill and Speaker
2) Remove all long sleeved items
3) Open door fully and sit on the floor as far back as you can facing the rear
4) Feed in your arm.
Unless your arm is very wide, or you are short you should reach it at maximum extension up to your shoulder. I am only 5'7 and no way skinny and can do OK. Getting the nut off with a spanner takes a while.
For refitting use wingnuts. You can them in B&Q in bags of 10 for a few quid. Can also be used for the dash.
If you are anywhere near south Bedfordshire I would be happy to give you a hand.
Cheers
Dave
1) Remove Speaker Grill and Speaker
2) Remove all long sleeved items
3) Open door fully and sit on the floor as far back as you can facing the rear
4) Feed in your arm.
Unless your arm is very wide, or you are short you should reach it at maximum extension up to your shoulder. I am only 5'7 and no way skinny and can do OK. Getting the nut off with a spanner takes a while.
For refitting use wingnuts. You can them in B&Q in bags of 10 for a few quid. Can also be used for the dash.
If you are anywhere near south Bedfordshire I would be happy to give you a hand.
Cheers
Dave
Gassing Station | Chimaera | Top of Page | What's New | My Stuff