supercharger drive for preserp chim
Discussion
as the title just thought you folks would like to see the wheel and adjuster i make for the pre serp engines to allow the fitting off the scpower blowers
john
Untitled by brundallmotorsport, on Flickr
Untitled by brundallmotorsport, on Flickr
Untitled by brundallmotorsport, on Flickr
Untitled by brundallmotorsport, on Flickr
Untitled by brundallmotorsport, on Flickr
Untitled by brundallmotorsport, on Flickr
Untitled by brundallmotorsport, on Flickr
john
Untitled by brundallmotorsport, on Flickr
Untitled by brundallmotorsport, on Flickr
Untitled by brundallmotorsport, on Flickr
Untitled by brundallmotorsport, on Flickr
Untitled by brundallmotorsport, on Flickr
Untitled by brundallmotorsport, on Flickr
Untitled by brundallmotorsport, on Flickr
the grade is T6 which can be anodised but is highly resistant to corrosion and i do use a single tool i grind them up from a brazed on tip of a boring bar you need a good magnifying glass to get it right, you can buy chasers but in my experience really only any good on a modern c and c machine.
john
john
here are the finished articles
john
Untitled by brundallmotorsport, on Flickr
Untitled by brundallmotorsport, on Flickr
john
Untitled by brundallmotorsport, on Flickr
Untitled by brundallmotorsport, on Flickr
Gassing Station | Chimaera | Top of Page | What's New | My Stuff