Discussion
Take that housing off and fit a core plug in the hole left Derek, now is the time with the motor out, you will have to block those tapped holes to (unlike this shot) then just put a bung over the opening near the TB and the jobs a good-un ..................... Yes LongBaz thats your plenum ..........
Edited by Sardonicus on Monday 7th March 12:34
LongBaz said:
Do I not need this on mine as I am running MS. If needs be I will make a plate up to cover the hole.
Plenum looks good Simon.
If idle is behaving itself Barry then no, I chose this way because I was sure the stepper would throw a wobbly and be inconstant controlling a bigger cams choppy idle etc Plenum looks good Simon.
I have had the same problem with those same gaskets previously. They aint big enough despite being sold as big bore.
The ones that Power sell are the perfect size and didnt need any fettling.
Worth checking manifold to head alignment as well Derek. My manifolds needed opening up quite a bit.
The ones that Power sell are the perfect size and didnt need any fettling.
Worth checking manifold to head alignment as well Derek. My manifolds needed opening up quite a bit.
Edited by carsy on Saturday 12th March 15:26
carsy said:
I have had the same problem with those same gaskets previously. They aint big enough despite being sold as big bore.
The ones that Power sell are the perfect size and didnt need any fettling.
Worth checking manifold to head alignment as well Derek. My manifolds needed opening up quite a bit.
I had opened the manifolds previously but they showed tell tale signs of misalignment so I have opened them more. They are about a mm bigger al round than the gaskets and heads now so a little room for movement. The ones that Power sell are the perfect size and didnt need any fettling.
Worth checking manifold to head alignment as well Derek. My manifolds needed opening up quite a bit.
Edited by carsy on Saturday 12th March 15:26
The flywheel, clutch and bellhousing are fitted and the engine is hanging on the chainblock waiting to be lowered in tomorrow.
Afternoon Peter, I Buy all mine from here, so do loads of other racers.
http://www.mcgillmotorsport.com/
http://www.mcgillmotorsport.com/
77racing said:
Afternoon Peter, I Buy all mine from here, so do loads of other racers.
http://www.mcgillmotorsport.com/
Err, "Derek"http://www.mcgillmotorsport.com/
It's an age thing Bill, don't worry,
Gassing Station | Chimaera | Top of Page | What's New | My Stuff