Series 1 vs series 2 the differences???
Discussion
Another small change is the otter switch location - in the bottom of the swirl pot on earlier cars, on the back of the radiator on later cars.
Very early cars had no power steering IIRC, and the inside door knob was by the gear lever, not further back.
Wiper motor location is different too, and earlier cars had 240mm front brakes, later 260mm
If I have repeated stuff that's above, then sorry, but as you know you cannot see it once you start tryping
Very early cars had no power steering IIRC, and the inside door knob was by the gear lever, not further back.
Wiper motor location is different too, and earlier cars had 240mm front brakes, later 260mm
If I have repeated stuff that's above, then sorry, but as you know you cannot see it once you start tryping
cejsmith said:
So by 96 a chim should be serp, with updated diff and gearbox, but older body style? Or is it still the case that it could be made of what ever was lying about in Blackpool???
It should be serp engine (longer, grooved aux belt vs shorter V belt on pre-serps), T5 box, BTR diff, mark one front and rear ends, with fiesta rear lights (later ones, 98/9 on, are 4 single lights behind smoked perspex each side, and are landrover), earlier dash layout I think.The rare tow-bar and roof rails were optional extras on later cars for customers who had spotted the Landrover rear lights and were on their way to Specsavers
Gassing Station | Chimaera | Top of Page | What's New | My Stuff