Megasquirt experts !!

[4i turbo bob]

I have a torque v8 turbo conversion on my 500..could finish mapping because clutch gave up..
New clutch fitted..leak in plenum sorted..
Goes like stink..just needs the map tidying up.
Any recommendations in Kent? ?

Ta
Rob

[4i turbo bob]

It's ms2 v3.0 with Ms extra ???

[sgrimshaw]

You can't do better than to contact Shaun at ms2tuning.

http://www.ms2tuning.com/index.html

[Smokey Boyer]

I know Shaun is not local to Kent as he is based in Lincolnshire, and that might be a show stopper, but I have found him to be very good. However, I hope there must be more than him as a MegaSquirt and Rover specialist worth letting loose on our cars. Any other recommendations very much welcome.

[4i turbo bob]

Localish to Kent would be good..
Not many mappers interested in megasquirt

[phazed]

Shaun did mine in Surrey so Kent is OK I would say.

[4i turbo bob]

Ok..
Maybe back on then ))
I have sent him a mail..
Did he map it on the road orange on the rollers ?

[Engineer1949]

he did the 400sx i supercharged and did a fantastic job in pouring rain on the road which is his preferred method.


john

[phazed]

Engineer1949 said:

he did the 400sx i supercharged and did a fantastic job in pouring rain on the road which is his preferred method.


john

Ditto on my 4.6.

[boxer456]

Ditto Johns comment, Shaun did a brilliant job on the 400 sx. Very impressive, highly recommend his mapping on the MS!

[Smokey Boyer]

He has mapped mine on the road twice, and carried out some remote mapping and tweaks with the car sat on the drive. Doing the 6 second wide open throttle runs in 2nd through to 5th gears is little scary in a 500 Chimaera. Give it a try, start at around 20 or 30mph with almost no throttle and then foot flat to the floor until you loose your bottle or he tells you to stop. Repeat a few times in all gears......

He has also worked from logs taken from tuner studio, and sent me back adjusted maps.

I know he will map on a rolling road as well, but he prefers doing it on the road. He does not seem keen on wasting anyones time or money mapping the car on a rolling road unless it is absolutely essential.

Top bloke....

[4i turbo bob]

Mines a turbo..All he'll breaks loose from 2500 rpm. ))
Sounds like shaun is the guy I need.
Glad to here I'm not the only one using ms..
Seems to be a dirty word amongst the usual suspects.

[sgrimshaw]

Shaun will travel to you at an extremely reasonable cost.

His on the road approach to mapping works very, very well.

All in all, it's a far cheaper option than a RR session and you'll also learn a lot.

[4i turbo bob]

Thanks guys.
Most helpful.

[AceOfHearts]

I can highly recommend Dale at Bailey Performance but not local to you either i'm afraid. Very reasonably priced and a very knowledgable guy. I know he has mapped some of the very big power chims on here. I will be going back to him once my turbo is installed.

[4i turbo bob]

Have spoken with shaun..
Be sorted end of month hopefully.
Cheers all
Rob