polo 1.4s 2002
Discussion
Hi there Guys,
Hope you guys had good weekend.
Bought a 1.4s polo yesterday and last night noticed the drivers side headlight is newer than the pax side. In addition, the drivers side, the beam is higher. Other than the electronic adjust, how can this be adjusted to the correct direct of beam? manually? any easy diy steps photos?
Also plugged in my code reader and had 2 error codes
P0170 and P1180. but no management light on.
After clearing it, the management light came back on with P1180 code. The vehicle has 70k miles and timing belt, water pump, manifold(replaced as damaged) and changed along with oxygen sensor.
Turned off codes with my code reader and was fine all day. Turn vehicle on tonight and management light on again. Look under the car and looked like slight condensation coming from joint after cat. Is that where oxygen sensor is?
Panicking a little as only purchased yesterday.
Your help will be much appreciated.
Look forward to your help
Regards
Nick
Hope you guys had good weekend.
Bought a 1.4s polo yesterday and last night noticed the drivers side headlight is newer than the pax side. In addition, the drivers side, the beam is higher. Other than the electronic adjust, how can this be adjusted to the correct direct of beam? manually? any easy diy steps photos?
Also plugged in my code reader and had 2 error codes
P0170 and P1180. but no management light on.
After clearing it, the management light came back on with P1180 code. The vehicle has 70k miles and timing belt, water pump, manifold(replaced as damaged) and changed along with oxygen sensor.
Turned off codes with my code reader and was fine all day. Turn vehicle on tonight and management light on again. Look under the car and looked like slight condensation coming from joint after cat. Is that where oxygen sensor is?
Panicking a little as only purchased yesterday.
Your help will be much appreciated.
Look forward to your help
Regards
Nick
Gassing Station | Audi, Seat, Skoda & VW | Top of Page | What's New | My Stuff