stud size

Author
Discussion

paul2000

Original Poster:

743 posts

219 months

Sunday 20th July 2014
quotequote all
HI lads need your help again can anybody tell me the standard size of the wheel studs on a griffith iseem to have one side that is longer than the other so not sure which side is the right size hope you can help as would like to put this right many thanks paul

Plan B

347 posts

124 months

Monday 21st July 2014
quotequote all
Mine protrudes 27.5 mm through the disc

Pete Mac

755 posts

136 months

Monday 21st July 2014
quotequote all
Paul, probably a bit over the top but if you are going to do the job, you might as well do it properly. From my 95 Griff in bits:

Overall stud length is approximately 52mm:



Thread length is approximately 27mm:



Thread is M12 x 1.5



As far as I can see, all the studs are the same and are almost certainly original equipment.

I hope this helps. Pete

paul2000

Original Poster:

743 posts

219 months

Monday 21st July 2014
quotequote all
HI pete thats,great info just what i needed, its all there thank you very much . paul

paul2000

Original Poster:

743 posts

219 months

Monday 21st July 2014
quotequote all
I almost forgot can any one tell me the best place to get hold of them many thanks paul

Pete Mac

755 posts

136 months

Tuesday 22nd July 2014
quotequote all
paul2000 said:
I almost forgot can any one tell me the best place to get hold of them many thanks paul
Just been up to Racetech, they seem to have the studs at a reasonable price compared with others. Pete

paul2000

Original Poster:

743 posts

219 months

Tuesday 22nd July 2014
quotequote all
many thanks again pete will give them a call in the morning thank paul

paul2000

Original Poster:

743 posts

219 months

Tuesday 22nd July 2014
quotequote all
many thanks again pete will give them a call in the morning thank paul