Range Rover classic

[dunk7]

[smnd]

HI Dunk7, amazing job. Out of curiosity, how much (roughly) is the whole project going to cost?

[Shaw Tarse]

dunk7 said:

Going to get all the wood re veneered due to the centre section
around the gear change having a small area of damage

Any suggestions who to use ?

Edited by dunk7 on Tuesday 3rd March 08:43

I was trying to remember who on PH did re veneering, http://www.pistonheads.com/gassing/topic.asp?t=133... doesn't look like he's posted for a while

[dunk7]

Interior light panel is back in with new lens and new lens in
the rear light as well

[dunk7]

[dunk7]

You can't really see them but fitted brake & breather pipe clips
rather than just have them cable tied

[dunk7]

[dunk7]

smnd said:

HI Dunk7, amazing job. Out of curiosity, how much (roughly) is the whole project going to cost?

Thanks mate, i've not added up all the invoices yet and still have
a fair bit to do/buy, i think the parts bill on its own is over £14k but
that does include the new JE engine

[dunk7]

Shaw Tarse said:

I was trying to remember who on PH did re veneering, http://www.pistonheads.com/gassing/topic.asp?t=133... doesn't look like he's posted for a while

Thanks for posting the link that's very good of you to find
it.

I'll pm saladin and see if he's still doing trim panels

[dunk7]

Spent the morning going over the replacement bonnet, my good
mate Richard doing the panel beating and myself removing all
the surface rust

[dunk7]

[dunk7]

[dunk7]

[dunk7]

My good friend Ibrar who owns Speedwells Alloy wheels sent me a
photo of my wheels that he's just finished refurbishing for me.

[dunk7]

Hopefully wont be too long before it goes into the paintshop
and get the new bonnet on and do all the required paintwork along
with a bit of adjusting on the panel gaps

[dunk7]

Spent yesterday cleaning the inside, started with the leather
using Gliptone leather cleaner then their conditioner.

Very happy with the results but 7 hours hard work

[dunk7]

[dunk7]

[dunk7]

[dunk7]