Tailgate Fin T350

[SP6 Animal]

Anyone fitted a Sagaris fin to this car was wondering how you fitted it.
Thanks

[the jollyrodger]

ive seen one fitted to a t350,it was held on by 4 brackets as opposed to 3 with the sag,reason being the boot release badge being in the middle.
you seem to be doing a lot of work to this car!

[SP6 Animal]

the jollyrodger said:

ive seen one fitted to a t350,it was held on by 4 brackets as opposed to 3 with the sag,reason being the boot release badge being in the middle.
you seem to be doing a lot of work to this car!

No that's the next job
I mean the fin that pulls the glass up/down the bracket won't fit i need the sag one but can't get one.
Unless anyone has any better ideas.
Could drill through it but too close to the edge bolts might look poor.
Glued it on as a temp measure not sure how long it will hold.

[L BOOTHY]

I fitted handle to my t350 by drilling existing back plate and using longer bolts..You have the earlier type body shell without the finger access so not sure if it will foul bodywork.

[the jollyrodger]

is this 'fin' to open the boot or is it just to lift the glass with? my boot is getting harder to open and i need to push it several times now. can it be got in black?,
thanks,david.

[grumbledoak]

the jollyrodger said:

is this 'fin' to open the boot or is it just to lift the glass with?

How do you open your 'boot'?

[SP6 Animal]

Decided to drill the plate but gave it someone else to do it.
As you can see close to the sides.

After that 2 bolts job done a easy mod no more lifting the glass from the side.

Thanks to lee for his guidance

[doctor_darren]

I got one fitted to my T350C at Christmas by TrackVRoad, they did the same, just drilled the base through from the back and fitted longer bolts. IRC they got the fin from Multipart. Being honest I wanted it for the look but it really makes a huge difference to opening the rear window, so much easier.

Dr Darren