Griff Door Mirror
Discussion
Probably a knackered motor in the mirror.But could be a bad connection in the mirror control circuit.
To get the door panel off:
Remove the door speaker.
There are 3 6mm (10mm socket) retaining nuts
1 to the left of the speaker hole. 1 either side of the door pull handle, these arent easy to get to , (hope you dont have big arms).
Remove the screw from behind the ash tray.
Remove the screws holding the rear door trim reflector.
The panel should now lift up and away.
Edit to Add,
To get the door panel off:
Remove the door speaker.
There are 3 6mm (10mm socket) retaining nuts
1 to the left of the speaker hole. 1 either side of the door pull handle, these arent easy to get to , (hope you dont have big arms).
Remove the screw from behind the ash tray.
Remove the screws holding the rear door trim reflector.
The panel should now lift up and away.
Edit to Add,
Edited by AntonyJ on Thursday 31st July 22:30
Pah,
I'd read all these horror stories about GRP rash all the way up your arm and how much of a bugger the job was. Tosh I say, Tosh!
Remove your speaker
Undo the screws holding the reflector, seen in this picture to the left of the word GREY

Then undo the screw behind the ashtray, and the bolts highlighted with yellow tape in this picture

Robert's your dads brother.
Putting it back on was a different story though.
Getting the lip at the top of the door card over the edge of the door was a complete pig, so watch how you have to wiggle yours to get it off because it may help when you come to put it back on.
Having said all that, my sincere thanks go to Antonyj for his help when I was doing this for the first time.
I'd read all these horror stories about GRP rash all the way up your arm and how much of a bugger the job was. Tosh I say, Tosh!

Remove your speaker
Undo the screws holding the reflector, seen in this picture to the left of the word GREY

Then undo the screw behind the ashtray, and the bolts highlighted with yellow tape in this picture

Robert's your dads brother.
Putting it back on was a different story though.
Getting the lip at the top of the door card over the edge of the door was a complete pig, so watch how you have to wiggle yours to get it off because it may help when you come to put it back on.
Having said all that, my sincere thanks go to Antonyj for his help when I was doing this for the first time.
Edited by Barreti on Friday 1st August 07:43
Gassing Station | Griffith | Top of Page | What's New | My Stuff





