Panel Wipe & Lacquer Woes

Panel Wipe & Lacquer Woes

Author
Discussion

Lund

Original Poster:

1,743 posts

211 months

Tuesday 1st November 2011
quotequote all
Replaced my number plates front & back on the Audi and used panel wipe to remove the stickiness of the previous sticky pads, however I now appear to have white hazed smears where I have wiped the residue area. Tried to get at it with the bog standard polish, to no avail. Looks to have clouded the lacquer, is it worth using some Freckler? - I'm trying not to make it any worse!

Cheers

The Rustman

225 posts

170 months

Wednesday 2nd November 2011
quotequote all
Not sure if thats going to get rid of the bloom it depends how deep its gone.

I use WD40 on the glue residue it works really well

paintman

7,693 posts

191 months

Wednesday 2nd November 2011
quotequote all
Sure you've not just smeared some of the glue around?
I'm surprised panel wipe has done that, wasn't actually thinners was it? (Or has a repair been done to the area with dodgy lacquer?)
WD40 as said usually works well.
I use brake & clutch cleaner to remove glue residue from caravans after removing decals & the glue on those can be a complete PITA to get off - not had a paint damage issue yet.
Can you cover the area with the new plate? If not then you may as well try polishing as the alternative would be a repaint.

domster

8,431 posts

271 months

Thursday 3rd November 2011
quotequote all
Do you mean FARECLA - as in G10, G3 compounds?

The paint will be very soft if attacked with solvent, so leave it a few weeks before compounding, just to be safe. If on a PU ie plastic bumper then strike through with soft paint is more of a hazard.

As previous posters say, identify whether glue residue or actual lacquer bloom first by allowing it to dry then reapplying mild solvent like WD40.

Lund

Original Poster:

1,743 posts

211 months

Thursday 3rd November 2011
quotequote all
domster said:
Do you mean FARECLA - as in G10, G3 compounds?
hehe Thats the stuff!

My panel wipe cloth may have been previously used as the thinners cloth frown

domster

8,431 posts

271 months

Thursday 3rd November 2011
quotequote all
Toluene thinners are pretty lethal... they could certainly 'rough' up the finish enough through softening to cause a misty or milky effect. You will need to wet flat and then polish this - but check when it has fully cured/hardened in a few days.

kds keltec

1,365 posts

191 months

Friday 4th November 2011
quotequote all
As paintamn said , seen panel wipe damage cheap smart repair 1k lacquer before .

Pictures of the area would help us all a bit .

kelly