V8 tyre pressure fault
Discussion
I recently got the two rear tyres replaced on my V8VR.
The guy at the tyre shop said to me there was a procedure to follow when replacing wheels/tyres fitted with TPMS.
I do not know what the procedure is, but in my case even when I got back into the car after the tyres being fitted there were no warnings on the dash.
I had assumed that I would have to drive the car for the sensors to reset.
I do recall at the time the tyre fitter blowing up the new tyres very slowly.
The guy at the tyre shop said to me there was a procedure to follow when replacing wheels/tyres fitted with TPMS.
I do not know what the procedure is, but in my case even when I got back into the car after the tyres being fitted there were no warnings on the dash.
I had assumed that I would have to drive the car for the sensors to reset.
I do recall at the time the tyre fitter blowing up the new tyres very slowly.
Have you got new valves? the sensors are fitted to the bottom of the valve, so if you have new valves they probably binned them? No sensor = tyre warning light.
If you still have the original valves, did they knock them? they are very fragile. There is no reset but they can be adjusted for sensitivity with the tyre off.
If you still have the original valves, did they knock them? they are very fragile. There is no reset but they can be adjusted for sensitivity with the tyre off.
Gassing Station | Aston Martin | Top of Page | What's New | My Stuff