PAS steering rack lines
Discussion
Anyone know if the hard lines into the distributor can be switched for flexis with banjo fittings - need to remove the obstruction the current hard lines represent but am wondering if there's an inverted flare in there that will prevent a banjo being used? Think the thread might be 1/4BSP?
Any good Gary? http://www.tvrpower.co.uk/store/slug/steering-rack...
Saw those thanks (think you've flagged them before), but they stand off too far above the rack... banjo would be much lower profile but the ports might be too close together even if a banjo bolt would screw in. Remake the pipes with tighter closer bends maybe... just looks like 8mm copper?
I've done the pressure feed, just needed a wide m/f bsp to raise the joint for clearance and obviously provide a nice flat brass flange for the banjo to sit on. You can always check the surface with a doughty washer to see if it might seal, but a male-female adapter should only raise it @1/2" + the banjo width & bolt head.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff