Top tips inlet porting / flowing

Top tips inlet porting / flowing

Author
Discussion

jojackson4

Original Poster:

3,026 posts

136 months

Tuesday 19th May 2015
quotequote all
picked up a cheap manifold and fancy having a go at opening it up a bit
Never tried or had a go at this so am after some tips

Is a 500 which will have a blended bace when I have done
Thanks
Peter

Chuffmeister

3,597 posts

136 months

Tuesday 19th May 2015
quotequote all
You can only get so far into the chamber from what I understand. I asked the same question myself a few months ago. I have one too, so may have a go whilst the car is out of the garage.

RCK974X

2,521 posts

148 months

Monday 25th January 2016
quotequote all
The idiot's guide to porting ->

Stage 1 = get rid of all sharp edges. (can also match ports to head, it helps.)
Stage 2 = get rid of all bumps/narrow bits.
Stage 3 = make everything wider & taller, including the valves.

Yeah, I know, but this is the principle of it.

Along with -

It's EASY to supply more fuel, what's hard is to get the air in and out to match it.

eliot

11,364 posts

253 months

Monday 25th January 2016
quotequote all
jojackson4 said:
Is a 500 which will have a blended bace when I have done
Peter
What's a 500? The existing engine or the manifold you have purchased? The manifold on a 500 is already ported to an extent - the inlet runners on the top are 44mm to match the OEM "scaffold tube" trumpets.

jojackson4

Original Poster:

3,026 posts

136 months

Monday 25th January 2016
quotequote all


Now about 48 mm

jojackson4

Original Poster:

3,026 posts

136 months

Monday 25th January 2016
quotequote all
The steps are all gone
There's a bit more todo but is 90% there
Just after a spare plenom so I can do the big butterfly

packman10_4

245 posts

193 months

Monday 28th November 2016
quotequote all
Let someone do it who knows what there doing ... you cant really put metal back in after using a carbide bit to remove it ...

fredd1e

781 posts

219 months

Tuesday 29th November 2016
quotequote all
Bigger doesn't always mean better, holes that are too big or the wrong shape will ruin the gas-flow /fuel mixing the engine wants. Beyond removing the casting flashes and port alignment to the head (and if the head holes are bigger than manifold ports this may be not a good thing to do) . Get an expert who has experience and results in what you want from the change, and/or have a spare part/engine on hand for when its worse afterwards. Note seat of the pants testing rarely shows any benefits, e.g. holes created in low range torque often feel like rises in power high up as the engine climbs out of the hole created, and if the fuelling ignition etc isnt set to take advantage then your just finding a way to pass time and create metal particles.

jojackson4

Original Poster:

3,026 posts

136 months

Tuesday 29th November 2016
quotequote all
Thanks for the input gents
The manifold is going on in a weeks time
And then off to jools for a map I will post back with results