Abs fault

[GaryManycars]

Took the vxr springs off the rear of the ute yesterday to replace with the stock ones, then had to adjust the handbrake for an mot this week, driving it today and abs warning light came on, anything I could have done to make this happen?
Typical the car breaks when it's for sale lol

[ARAF]

Could you of knocked a sensor, or not plugged one back in?

[GaryManycars]

Possibly mate, at work so can't look till tonight now, fingers crossed it just fixes itself lol

[GaryManycars]

Light still on, nothing disconnected, as I pulled away the abs was kicking in initially at slow speeds, then light went out and braking normal, half mile up the road and light back on again, braking absolutely fine but didn't push my luck, will get a try to get a code in a bit, any ideas?

[ARAF]

Knackered. I'll give you a tenner for the Ute - as long as you deliver it.

I still think you've probably just disturbed something, and that if you clean and check the ABS sensor locations and their connectors, you should clear the fault.

Failing that, take the bulb out.

[GaryManycars]

As expected no codes

[GaryManycars]

ARAF said:

Knackered. I'll give you a tenner for the Ute - as long as you deliver it.

I still think you've probably just disturbed something, and that if you clean and check the ABS sensor locations and their connectors, you should clear the fault.

Failing that, take the bulb out.

Will check again in the morning but everything looked as it should underneath, mot first thing Wednesday, great!

[motomk]

Load sensing proportioning valve?

[GaryManycars]

motomk said:

Load sensing proportioning valve?

That's a very good point, the ute has not landed in its correct stance yet, have tried to bounce on it but that's not worked lol, have checked all wiring/fuses/fluids and all ok, I think a few launches might help today maybe, that won't be fun though!

[GaryManycars]

As I hoped after a good run its now cleared itself, love fixes like this and will miss that about it