Roll cage hoop bar S2
Discussion
I recently purchased a rollbar from Rollcentre. While the construction quality was very good, their design requires you cut larger holes in the rear shelf fiberglass to install for the rear mounting plates. If I had had a custom unit built, I would have designed the rear mounts as separate pieces with a tube attached that would bolt to the tubes coming through the rear shelf. (I suppose you could always ass them to modify their stock design).
Also, since there always are slight differences between cars, the premade unit required I shim the front plates to get the upright in the correct position.
My $.02.
Also, since there always are slight differences between cars, the premade unit required I shim the front plates to get the upright in the correct position.
My $.02.
Griffinr said:
Was this with the body on? What do the front bars bolt to. Do you have any pictures/fitting details. Thinking of getting one myself, started to feel a bit vulnerable in my old age.
Rob.
Hi,Rob.
Yes the plates were welded on with the body off and are very similar to Magpies.
The main hoop bolts the the bodymount/seatbelt reel mounting plate and the reel has a new attachment point welded to the roll bar.
Bill
Gassing Station | S Series | Top of Page | What's New | My Stuff