Driveshaft needed

[bill tvr]

Anyone got one forsale ...again thanks to Darren for the loan of his ...and his tools

[77racing]

What you using Bill , GKN or Granada ?

[bill tvr]

I'm not sure Perry JR said I needed GKN... What you got ?

[NTEL]

I think I might have one Billy. Its an off side one to suit Granada CV joint. I'll have a look in the morning. It'll fit yours. When one of mine went Darren Dowling lent me one of his. It was a bit longer but the splines matched and there was enough slack in the system to accept the extra length....ooooohhhh errrrr missus!

Edited by NTEL on Sunday 16th August 00:27

[77racing]

sounds like dave has it covered for you,but just in case i can point you to granny ones for sale ,cheap as chips. The much stronger ones GKN not made any more JR might have stock. Third option is unbreakable but that costs bear in mind they will be a lot cheaper than a race weekend.

[bill tvr]

NTEL said:

I think I might have one Billy. Its an off side one to suit Granada CV joint. I'll have a look in the morning. It'll fit yours. When one of mine went Darren Dowling lent me one of his. It was a bit longer but the splines matched and there was enough slack in the system to accept the extra length....ooooohhhh errrrr missus!

Edited by NTEL on Sunday 16th August 00:27

Thanks Dave ...give me a bell tommorow mate

[bill tvr]

NTEL said:

I think I might have one Billy. Its an off side one to suit Granada CV joint. I'll have a look in the morning. It'll fit yours. When one of mine went Darren Dowling lent me one of his. It was a bit longer but the splines matched and there was enough slack in the system to accept the extra length....ooooohhhh errrrr missus!

Edited by NTEL on Sunday 16th August 00:27

Thanks Dave ...give me a bell tommorow mate