3 or 4 point harness in a 996
Discussion
Just spent all afternoon fitting a new bucket seat to the GT2 and had a quick look round for somewhere to put the harness.
Should be OK with the lap fixings as i can steel the seat belt bolt hole on the side and there is enough meat on the seat mounts to bolt an eye bolt to.
BUT where do you put the one or two rear fixing for the shoulder belts, i looked in the engine bay and i doubt i could get my hand in to put one on the bulkhead.
Any ideas ?
Should be OK with the lap fixings as i can steel the seat belt bolt hole on the side and there is enough meat on the seat mounts to bolt an eye bolt to.
BUT where do you put the one or two rear fixing for the shoulder belts, i looked in the engine bay and i doubt i could get my hand in to put one on the bulkhead.
Any ideas ?
DanH said:
You need a harness bar or cage.
Shouldn't be needing to mess with eye bolts if you get the correct Schroth GT3 harnesses. There is a harness bar you fit onto the seat mount for the sub straps.
Do you mean a straight bar that fits across the back and bolts to where the rear seats, seat belt holes are located ?
Pork_n_Beem said:
DanH said:
You need a harness bar or cage.
Shouldn't be needing to mess with eye bolts if you get the correct Schroth GT3 harnesses. There is a harness bar you fit onto the seat mount for the sub straps.
Do you mean a straight bar that fits across the back and bolts to where the rear seats, seat belt holes are located ?
Well you can get this, but frankly you may as well get a cage.
www.bkauto.com/porsche/harnessmount.php
Gassing Station | Porsche General | Top of Page | What's New | My Stuff