Discussion
The Hot/Cold control on my Chim does not seem to be working correctly.....in other words, it only blows out hot air.
The only way i can get cold air into the cabin is by using the separate blower control on the drivers side and this blows cold air out of the offside air vent only.
Its not a major problem as i drive most of the time with the hood down.
Any ideas anyone ?
The only way i can get cold air into the cabin is by using the separate blower control on the drivers side and this blows cold air out of the offside air vent only.
Its not a major problem as i drive most of the time with the hood down.
Any ideas anyone ?
Does the dial that should control the flow of air over the heater matrix feel like it's connected and doing something when you turn it? Or does it just go round and round with no feeling of resistance? If the latter then it's probably the cable that has become disconnected/broken.
Removing the top of the dash (or rather lifting it up) is covered in a previous thread. A PHer has a website with info on this including piccies - you should be able to find this using the search facility.
Removing the top of the dash (or rather lifting it up) is covered in a previous thread. A PHer has a website with info on this including piccies - you should be able to find this using the search facility.
GAZ_3884 said:
And the fans? Range from 'Off' to 'A Very Slight Movement of Air'
Blimey - I've had to superglue my toupe (is that how you spell it?) in place as the fans blow it off
You wanna check the pipes are properly connected to the vents (mine weren't on the driver's side when I got the car)
Gassing Station | Chimaera | Top of Page | What's New | My Stuff