SOmeone asked these questions again so I thought Id get this stickied

As Im Going through the process of building up the chassis and Finding parts I thought I'd start to list them, what they are from, part Numbers, and places i got them from.

feel free to add / amend anything you've found


Front Suspension

Rose Joints 1/2"*1/2 UNF Right handed * 4 each side
Top Ball Joint - 1989 Jaguar XJ6 : FIA part number SS027
Bottom Ball Joint - 1989 Jaguar XJ6 : FIA part number SS028
Track rod ends - QH part number QR2212S Equiv : MTR2212 or ftr4179 firstline
Wheel Studs - Ford Transit -Part No 1015829

Wheel Bearings for later stub axles - Timken XAA32008X ISOClass. these have the larger radius on the outside of the inner race than std bearings the same size







Rear Suspension

Bearing Carrier - Ford Granada -Part No 6146626
Hub - Ford Granada -Part No 1637225
LH Output flange - Griff/Chim - Part no R0038 - Bell Hill Garage / TVR dealers
RH Output flange - Griff/Chim - Part no R0039 - Bell Hill Garage / TVR dealers
Drive Shaft - Griff / Chim - Part no R0093 - Bell Hill Garage / TVR Dealers
Rose Joints 1/2" * 1/2" R/H UNF *6 each side
Rose Joints 1/2" * 5/8" R/H UNF *1 each side
wheel studs - Ford Transit Part No 1015829
Wheel bearing - Ford Granada


Note the hubs are different to chim/griff as chim/griff are 4 stud. I understand you also need to machine down the hubs toget the disk bells to fit.

also the new bearing carriers have caliper lugs which can be machined off.

You could probably get the entire hub,carrier,drive flange,driveshaft from a granada cosworth, as the cv joints appear to be the correct size.