any tips for getting the swirl tank screw out?
Discussion
Call me a wimp, but I can't manage to get the brass screw on the swirl tank of my 99 (serpentine) chim
Screwdriver not a hope, using a spanner as a lever is a no go either - it seems to be completely tight and won't unscrew. I'm wanting to check the coolant levels and bleed the rad, but not much hope without getting the header tank screw off!
Anyone any ideas - are there any tools you guys use or any tips you could give me?
Thanks
Screwdriver not a hope, using a spanner as a lever is a no go either - it seems to be completely tight and won't unscrew. I'm wanting to check the coolant levels and bleed the rad, but not much hope without getting the header tank screw off!
Anyone any ideas - are there any tools you guys use or any tips you could give me?
Thanks
When the swirl pot/engine is warm you can loosen the brass screw quite easily. Only slacken it off though - don't loosen it all the way off when it is under pressure. Then, when everything has cooled down it is easy to undo.
I use the 'shaft' of a large screwdriver sideways in the groove to give enough leverage.
T/.
I use the 'shaft' of a large screwdriver sideways in the groove to give enough leverage.
T/.
shpub said:
As described in Bible 2, a two foot long pry bar is perfect for this. I copperslip the plug when putting it back to make it easier next time.
Cheers Steve. I am (of course ) using the destructions in the good book, but while my inherited set of tools is fairly good, a 2 foot ply bar is not something I have in my possesion There's an idea for the Bible Mk3 though - essential tools listing for those supposedly straightforward jobs!
Gassing Station | Chimaera | Top of Page | What's New | My Stuff