Emerald Triple Map Switch ?

[rev-erend]

Hi - has anyone fitted the Emerald Triple Map Switch ?

I was kind of expection the usual rear of the switch to have 3 flat blade connectors but it has an outer ring of smaller connectors (about 12) and an inner ring of 4 small connectors.

There is also a 1 ohn resistor - which page 40 of the manual shows as going to earth but is it soldered along side the cable (parallel) of in series - as it shown in the manual..

[trackcar]

I just use a three position toggle switch and wire it through the other serial connector. Hassle-fre install like that.

[rev-erend]

trackcar said:

other serial connector.

Thanks - what's the other connector ?

[trackcar]

there's two serial connectors on the casing .. one for the mapping lead and one with a rubber cover over it, the ecu manual shows you how to connect the map switch into this serial connector. I think there's a way to do it through the big K series plug but I've never bothered as using the other serial connector is easier.

[CNHSS1]

ive got it fitted but Dave 'the Jedi' Walker fitted mine so cant tll how its wired. very useful on track though, can alter the cars 'manners' for the conditions very easily

[CNHSS1]

if you get no joy, drop me a line and i will photograph my setup and the wiring.

[rev-erend]

CNHSS1 said:

if you get no joy, drop me a line and i will photograph my setup and the wiring.

OK - Thanks..

Question is with Emerald.. Leooni says it gets asked plenty of times..