RWD Rover Turbo
Discussion
Easiest way would be to use a Rover SD1 box (2litre bellhousing) and a late sherpa 2litre Starter motor/flywheel/clutch to suit the crank shaft sensor(its in the back plate and works off the flywheel)Starter on the sherpa is engine side rather than gearbox side. There was an MGB with a rwd T16 turbo set up in one of the mags recently (PPC?) not 100% certain which one though.
what's it going in? and good luck!!
Mark
what's it going in? and good luck!!
Mark
Gassing Station | Engines & Drivetrain | Top of Page | What's New | My Stuff