Discussion
I know it's cr@p but last night I pulled it on and it went completely slack. I think the plastic thingies slipped. I was going to try and tighten it up again and put some hose clips on the back side to try and stop it next time.
Meant to also add....
I assume tightening is toward the front of the car. Tried both directions but cant get enough leverage and my crowbar won't fit in the space.
Meant to also add....
I assume tightening is toward the front of the car. Tried both directions but cant get enough leverage and my crowbar won't fit in the space.
Shouldn't be that tight, are you aware that it's a two part adjuster? Did you release the handbrake first?
Loosen rearmost 'nut' first then use the other to adjust, (clockwise I think, but not 100% certain). Unless the cable is really covered in crud then it should be adjustable by hand. Make sure that the rear handbrake drums don't bind afterwards.
Mike
Loosen rearmost 'nut' first then use the other to adjust, (clockwise I think, but not 100% certain). Unless the cable is really covered in crud then it should be adjustable by hand. Make sure that the rear handbrake drums don't bind afterwards.
Mike
Gassing Station | Cerbera | Top of Page | What's New | My Stuff