Pony v GT emblem on back (S550)
Discussion
Found some instructions on another forum:-
Rear Pony or GT or 50 year disc:
- plastic-welded to the black glossy decklid
- pop the trunk
- remove the trunk deck liner
- disconnect backup camera
- remove 4 bolts
- remove the black glossy decklid (PULL HARD on one side, then the other)
- use a utility knife to cut the spots of melted plastic holding the emblem
- I used a punch to tap out the pins after
- Warning, deck looks terrible with 4 holes. Consider getting a replacement logo, replacement deck piece, or Plasti-Dipping the stock logo instead of removing it.
- video:
https://www.youtube.com/watch?feature=player_embed...
Rear Pony or GT or 50 year disc:
- plastic-welded to the black glossy decklid
- pop the trunk
- remove the trunk deck liner
- disconnect backup camera
- remove 4 bolts
- remove the black glossy decklid (PULL HARD on one side, then the other)
- use a utility knife to cut the spots of melted plastic holding the emblem
- I used a punch to tap out the pins after
- Warning, deck looks terrible with 4 holes. Consider getting a replacement logo, replacement deck piece, or Plasti-Dipping the stock logo instead of removing it.
- video:
https://www.youtube.com/watch?feature=player_embed...
Gassing Station | Mustangs | Top of Page | What's New | My Stuff