Steering column play
Discussion
Hoping some one has an obvious answer
Replaced the top uj and have found there is still some play in the assembly.
Decided it must be the difficult to replace bukhead bearing but upon inspection found the bearing to be fine but the triangular shaft is a loose fit in the triangular hole.
Is there a method of adjusting this?
If not I'm considering shims and ct1
Replaced the top uj and have found there is still some play in the assembly.
Decided it must be the difficult to replace bukhead bearing but upon inspection found the bearing to be fine but the triangular shaft is a loose fit in the triangular hole.
Is there a method of adjusting this?
If not I'm considering shims and ct1
Gassing Station | S Series | Top of Page | What's New | My Stuff