Rear Wheel Bearing Orientation
Discussion
As the title really. I have all new bearings to go in my new rear hubs, and I'm assuming they fit in both sides 'back to back' as it were. Then dust covers after?
I confess the bearings I've used before are sealed units and orientation has never mattered. I'd hate to mess up something so simple...!
I confess the bearings I've used before are sealed units and orientation has never mattered. I'd hate to mess up something so simple...!
Ceejay73 said:
NO. Outer casing pressed in first with the narrow end of the taper inner most. Then the taper roller bearing (well greased). Then the lip seal.
Same for the other side.
Narrow end of the taper to the centre.
E.T.A. Don't be tempted to use the bearing to press in the casing, this can damage the rollers/casing resulting in a noisy bearing and totally wasted job.
HTH
Carl.
Very glad I double checked! Cheers.Same for the other side.
Narrow end of the taper to the centre.
E.T.A. Don't be tempted to use the bearing to press in the casing, this can damage the rollers/casing resulting in a noisy bearing and totally wasted job.
HTH
Carl.
Edited by Ceejay73 on Saturday 3rd October 11:21
This was with the ford manual too - poor from me! Sadly they don't show you and exploded diagram and it was difficult to see which way around they meant...
Gassing Station | S Series | Top of Page | What's New | My Stuff