TVR Logo - Laser Cut Stainless Steel
Discussion
Recently has these "2 layer" TVR logos made locally.
The logo layout is from a self-made CAD file (.dxf file is available) and the cost was approx. £4 per individual piece.
The ones shown in the photo are 13 x 5 cm, and smaller will also be possible.
If anyone wants the .dxf or .sldprt (Solidworks) files, drop me a PersMail.
The logo layout is from a self-made CAD file (.dxf file is available) and the cost was approx. £4 per individual piece.
The ones shown in the photo are 13 x 5 cm, and smaller will also be possible.
If anyone wants the .dxf or .sldprt (Solidworks) files, drop me a PersMail.
At the moment, I only have the CAD files for the logos shown in the first photos. These are approx. 50mm or alternatively, 40mm height.
What are the dimensions of the parts shown in the photos which you sent ?
Also, what did you mean by :
What are the dimensions of the parts shown in the photos which you sent ?
Also, what did you mean by :
Discopotatoes said:
... but there are none that have 4.8 available off the shelf ...
Incognegro said:
This is great. Haven't measured yet but would be interested in this to go in the TVR recess on the speed six cam cover. Is that the purpose of this?
Let me know more cost etc.
Regards
As mentioned, these were 13x5cm and were really just an exercise for me to learn how to use a CAD program. Since I do not have a Speed Six engine, I'm not sure what size is required for the cam cover recess, but this was not the original intention. I will use these incorporated in some stainless door sill plates and a rear plate to go above the exhaust in the S cars.Let me know more cost etc.
Regards
The 13x5 can be proportionally scaled down, no problem.
The cost is also mentioned above and I suppose the only problem is that I am not in the UK, but in Hungary, so the postage will be a few quid, depending on the required service.
Tim
Gassing Station | S Series | Top of Page | What's New | My Stuff