OBD/ ECU diagnostic port is located .......
Discussion
Port duly found where described but interestingly doesn't have the standard Ford traingular port on the end. So the Draper fault code reader adapter doesn't fit. Connector on the loom is a straight inline plug, with Brown, Brown/Green and Blue Green wires which according to the wiring diagrams are the ECU connecotrs. So wondering if anyone out there has found the same, and identified which wires would go where on the Standard Triangular port ? Wish I still had my Sierra to check in this instance !!
Thanks guys, wire/ pin arrangement spot on . Hooked up the fault code reader and happily set everything into service mode, and then did the ECU fault read out for which there were none ! Only thing the FCR doesn't seem to do is read the ECU when only the ignition is on... but otherwise all good.
Gassing Station | S Series | Top of Page | What's New | My Stuff