None starter

[jaapdog]

Hi I am a new member I have a tasmin with a jag d type body fitted, all wiring has been chopped(before I bought it) I now have ignition and a spark ,fuel pump runs but no start, does the injection system need a power supply to run the engine cheers jaap

[jaapdog]

hi again i have a good fuel supply to the fuel distribution unit ,but no fuel to the injectors [when cranking the engine], i have been told that the air sucked through the air ducting covering the large disc and goes to the throttle body {is this the case] the large flat disc on the metering unit moves freely up and down when i press it , i have been told not to strip the unit down . any ideas would be a bonus, ps i have tested the injectors all ok [ if all fails can i replace inlet manifold and carb to replace injection system it is a 2.8i

Edited by jaapdog on Saturday 25th March 11:37

[jaapdog]

hi thanks for help , on checking metering unit/pressure plate , i noticed a upright metal tube on the right of metering unit [ is this a breather or should it have a tube on it connected to ?? also there is an electrical two pin plug on the base of the pressure plate where does the wires go thanks again jaap

[jaapdog]

hi all please find pics of car and engine bay as requested

[jaapdog]

[jaapdog]

[jaapdog]

[jaapdog]

[jaapdog]