Opinions please

[hal 1]

After deciding to correct the castor angle on my kit i came up with this idea to gauge both castor and camber angles, the mounting holes i used run parallel to the ball joint fixings so i just marked out the castor angle on the ' gauge ' i made
the camber is set at neutral,
The gauge is marked at 5 and 7 degrees, showing set at 7, camber is neutral

Opinions please, any criticism accepted ( leaving myself wide open there )






|http://thumbsnap.com/joeiFX9B[/url]

[hal 1]

Thanks for the reply, I had a feeling I was doing OK but wanted other opinions, I had the car supported under the bottom ball joint so that it should have been sat as it would be on the road.

Thanks again, much appreciated
Hal